Test-MCQ Class 10-NCERT -Science-Chapter 12-Test-2

Chapter 12: Electricity

Multiple Choice Questions

No of Questions : 15                   Marks: 15


Please enter your email:

1. To determine the eguivalent resistance of two resistors connected in series, a student prepared two electric circuits, correct reading of ammeter in the circuits is

 
 
 
 

2. When parallel resistors are of three different values, the potential difference across its terminals is

 
 
 
 

3. A cell, a resistor, a key and ammeter are arranged as shown in the circuit diagrams of Figure12.1. The current recorded in the ammeter will be

 
 
 
 

4. In the following circuits, heat produced in the resistor or combination of resistors connected to a 12 V battery will be

 
 
 
 

5. Electrical resistivity of a given metallic wire depends upon

 
 
 
 

6. A current of 1 A is drawn by a filament of an electric bulb. Number of electrons passing through a cross section of the filament in 16
seconds would be roughly

 
 
 
 

7. Identify the circuit  in which the electrical components have been properly connected.

 
 
 
 

8. What is the maximum resistance which can be made using five resistors each of 1/5 Ω?

 
 
 
 

9. What is the minimum resistance which can be made using five resistors each of 1/5 Ω?

 
 
 
 

10. The proper representation of series combination of cells  obtaining maximum potential is

 
 
 
 

11. Which of the following represents voltage?

 
 
 
 

12. A cylindrical conductor of length l and uniform area of crosssection A has resistance R. Another conductor of length 2l and resistance R of the same material has area of cross section. 

 
 
 
 

13. A student carries out an experiment and plots the V-I graph of three samples of nichrome wire with resistances R1, R2 and R3 respectively  Which of the following is true?

 
 
 
 

14. If the current I through a resistor is increased by 100% (assume that temperature remains unchanged), the increase in power dissipated will be

 
 
 
 

15. In an electrical circuit three incandescent bulbs A, B and C of rating 40 W, 60 W and 100 W respectively are connected in parallel to an electric source. Which of the following is likely to happen regarding their brightness?

 
 
 
 

Please Enter Your Name, School Name & Class in the given below box and submit:

( results will be shown  on this page within few moments after submit  )


Question 1 of 16

Leave a Reply

Leave you Replay.... Your email address will not be published. Required fields are marked *